You can not select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
46 lines
2.0 KiB
46 lines
2.0 KiB
ifconfig stands for "interface configuration."
|
|
|
|
It is used to *view and change the configuration* of the network interfaces on your system.
|
|
|
|
Running the ifconfig command with no arguments, like this:
|
|
|
|
|
|
[source,bash]
|
|
----
|
|
ifconfig
|
|
----
|
|
|
|
...displays information about all network interfaces currently in operation. The output will resemble the following:
|
|
|
|
|
|
[source,bash]
|
|
----
|
|
|
|
eth0 Link encap:Ethernet *HWaddr* 09:00:12:90:e3:e5 // <1>
|
|
inet addr:192.168.1.29 Bcast:192.168.1.255 Mask:255.255.255.0
|
|
inet6 addr: fe80::a00:27ff:fe70:e3f5/64 Scope:Link
|
|
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
|
|
RX packets:54071 errors:1 dropped:0 overruns:0 frame:0
|
|
TX packets:48515 errors:0 dropped:0 overruns:0 carrier:0
|
|
collisions:0 txqueuelen:1000
|
|
RX bytes:22009423 (20.9 MiB) TX bytes:25690847 (24.5 MiB)
|
|
Interrupt:10 Base address:0xd020
|
|
lo Link encap:Local Loopback // <2>
|
|
inet addr:127.0.0.1 Mask:255.0.0.0
|
|
inet6 addr: ::1/128 Scope:Host
|
|
UP LOOPBACK RUNNING MTU:16436 Metric:1
|
|
RX packets:83 errors:0 dropped:0 overruns:0 frame:0
|
|
TX packets:83 errors:0 dropped:0 overruns:0 carrier:0
|
|
collisions:0 txqueuelen:0
|
|
RX bytes:7766 (7.5 KiB) TX bytes:7766 (7.5 KiB)
|
|
----
|
|
<1> *HWaddr* This is your MAC address. *eth0* is the first Ethernet interface. (Additional Ethernet interfaces would be named *eth1,* *eth2,* etc.) This type of interface is usually a NIC connected to the network by a category 5 cable.
|
|
<2> *lo* is the loopback interface. This is a special network interface that the system uses to communicate with itself.
|
|
|
|
|
|
|
|
*Configuring an interface*
|
|
|
|
ifconfig can be used at the command line to configure (or re-configure) a network interface.
|
|
|
|
This is often unnecessary since this configuration is often handled by a script when you boot the system. If you'd like to do so manually, you will need superuser privileges, so we'll use sudo again when running these commands.
|
|
|